Fluorescent Zorb Ball for Sale

All of our zorb ball are made with excellent welding machine from USA. It has stable Performance. We have more styles for your option.It is so stirring and funny. Design for your option and Made of very strong material. And we also can make Zorb ball use on water.

Hot Air Machine

High-Frequency Welder

Entrance of Zorb Ball(one or two )

Harness: one or two and non-harnessed

CE/UL Air Pump Photos

Usage Steps:

1. Inflate your ZORB BALL with our attached air pump.

2. Find the entrance , some have one entrance, some two entrances

3. Take off all sharp things with you, including high heels, mobile, watch, etc, leave them out of ball or put them in the shoe bag and grocery bag.

4. Fasten your seat belts, and check again to make sure the safety

Warning:

1. Persons have heart diseases, hypertension, or weak physique are not suitable to participate in this activity.

2. Less than 10 years old kids and more than 55 years elders are not suitable to play in the ball.

3. Don't bring any sharp things into the ball, so is high heels. And make sure no sharp things on rolling places.

4. After fasten your seat belts, please check again to make sure you are firmly strapped.

5. After the ball stops, please don't come out at once, just stay for two or three minutes there.

Maintain & Storage:

1. Disinfect and clean the ball regularly.

2. Check the ball before using. Any damage, please mend it with our repairing kit and glue.

3. After use, please remove sundries outside and inside the ball.

4. Before packing, make sure the ball is clean and dry.Then store it in cool and dry place.

How to Repair it?

1. Find out exactly where the leak is. Fill a spray bottle with a mixture of soap and water and spray it liberally on the zorb along the seams. You will notice that the solution starts to bubble up where the leak is located, so take note of the position os the hole.

2. Prepare the hole for patching. Dry the seam off, and make sure that it is completely deflated before attempting to patch the seam. If you have the patch kit that came with the zorb, you can use the prep solution to thoroughly clean the rubber before proceeding. Rubbing alcohol also works.

3. Apply plumber's goop liberally to the seam and let it dry for about 15minutes. If possible, apply some goop to the inside of the seam as well, so that it spreads out and gives an extra layer of protection when the zorb pressurizes.

4. Fill the zorb about halfway with air and wait another 30minutes or so to make sure that the goop has dried completely.